Tips For Maintaining Your Lund

Winter Layup and Storage

Tip #1 Hull

• Scrape off any barnacles or crusted marine growth.
• Scrub hull thoroughly to remove marine grows and scum.
• Inspect the underwater gear and propellers for excessive wear or damage.
• Remove the hull drain plug and store is a safe place.

• Wash the deck, superstructure and cockpit.
• Cleanall deck hardware(i.e. cleats, rails, instruments, etc.) and apply a coat of metal polish or wax.
• Clean the indoor/outdoor carpet.

• IMPORTANT! Consult your engine manual for specific instructions covering winterization of the engine. Your dealer is qualified to perform engine winterization. Do not attempt to winterize the engine yourself without the proper knowledge and equipment.

• Fill the fuel tank completely, or empty completely. Either method will minimize condensation. You may want to add a gasoline stabilizer solution to the fuel if the tank is to remain full.
• Follow the product manufacturer's recommended procedure.

• Remove battery, check water level, and store away from freezing tempuratures.
• WARNING! To prevent personal injury, wear goggles, rubber gloves, and protective apron when working with the battery. Battery electrolyte can cause severe eye damage and burns to the skin. In case of spillage, wash area with a solution of baking soda and water.

• Remove the drainplus or stand pipe from the drain in the livewell.
• It is important to remove the water reamining in the hoses and pumps. Use a compressed air hose in all fittings and drain holes to remove all remaining water.

• Disconnect suction hose from water supply(fresh/sea water) or if water supply is taken from a tank, drain water storage tank.
• Open all spray nozzles/taps.
• Run pump until remaining water is expelled.
• Disconnect inlet and outlet tubes.
• Run pump briefly to confirm that water has been expelled.
• Spray nozzles/taps shall remain disconnected until temperatures are above freezing.
• Never start a frozen pump. Even if it is drained in might contain a small amount that locks the rotor. Make sure fittings are securely connected when returned to service. See pumps Owners Manual for further instructions.

• Scrub all interior surfaces.
• Be sure to remove everything that can hold moisture and cause mildew.
• Personal Flotation Devices(PFD's) and other safety equipment must be cleaned and dried. If left on board, place them where air can circulate around them.
• Clean thoroughly dry the bilge area. remove all rags, sponges, or other cleaning materials from the bilge area.
• Allow the interior to completely air out for a few days.
• If you store your boat outside, we recommend that you do not store it with the canvas and bow set on. Cover with a storage cover(available from dealers), tarp, or plastic-especially if you live in an area of heavy snow. whatever material you use for a cover, be sure the boat is properly ventilated.
• After cleaning, make sure everything is thoroghly dry and air can circulate freely throughout the inside of your boat.

Remember that these tips can help you add life to your boat, and keep it looking like new.

If you have any questions about any of these tips, check with your Lund Dealer.